Slowness and disconnections

לעברית לחצו כאן

To switch from edit view to read view

To search in the Wiki

Home page > Bugs and their solutions > Slowness and disconnections

The Internet consists of the following components. Software> Computer> Router or Netstick> Internet Service Provider> NetFree Filter> Internet Service Provider> Website.
Surfing will be as quick as the slowest component in the chain. That means that one slow component is enough for everything to be slow.

When examining a problem of slowness, one must first examine the most likely factors.

The causes of slowness:

WIFI - The main cause of slowness in almost all cases is wireless communication that involves connecting via WIFI or through a mobile Internet (netstick). Wireless communication passes through the air and is therefore subject to interference from many electrical devices, it is very common that wireless communication has low reception, and browsing is sometimes good and sometimes poor, and therefore there are many disconnections. sometimes the netstick maybe faulty.
Synchronize settings between carrier and infrastructure - The second factor that can cause slowness is high DSL speed relative to the physical infrastructure capacity, sometimes decreases the speed Strengthens the DSL signal and then the Internet is much more stable and without errors and disconnections.
PC or Software - The third factor is computer or software. It is possible that a virus or other software downloads or uploads data to the Internet (possibly updates to Windows) and weighs on the network, as well as try to disable the anti-virus web shield and delete cookies.
Terminal equipment is faulty - Possibly the end equipment is faulty, router / network cable.
Other factors - ISP or filter or site. They are the least likely factor that has rapid problems,a and therefore should be tested only after all other possible factors have been examined.

Slow cellular surfing

As in general, surfing with a netstick may be less stable than surfing through a wired connection, mobile browsing speed is affected by many factors, and to reach the maximum speed must be trial-and-error.

• Reception - The quality of the reception depends on many variables, such as the distance between the transmitting antenna and the exact location you are in (in a protected space-ממ"ד, shelter-מקלט, minus floors will usually be poor), the temporary load on the local antenna, LTE antenna support (G4) Winds) and it may be a disruption of reception that can be caused by any electronic device, full reception signal does not necessarily indicate the quality reception.

• Bandwidth - There may be programs that capture Internet traffic such as Windows updates and so on, and in all the resources required for proper surfing,, you can disable the Windows updates in the computer settings itself (more recommended) and the filter settings by blocking the "Windows Update"

• Modem - In addition, it depends to a great extent on the quality of the netstick and the reception frequencies it supports (generation 4 is usually recommended for a considerable part of generation 3), also note that you connect to the right network and especially not to the second generation (GPRS / GSM / EDGE) which you can't surfe with them at all.

Tips

• Check with the supplier that you have not exceeded the browsing quota included in your package.
• Using a 4 generation (lte) netstick from a good and reliable company
• If your netstick supports 4G, check that you are connected to a 4G network
• Sometimes 3G in your location will be faster than 4G, try switching to 3G and check
• Blocking Windows Updates
• In case there is no good reception, changing a location such as switching to another room etc. or connecting the netstick via a USB cable extends and removing it outside of the window significantly improves
• in It is possible that with a company operating on other antennas you will have a better reception in your area, you can get help on this site.
• In the event that there is no choice ... Switch to a wired connection (infrastructure and supplier)

Tutorials

Block Windows updates automatically

up a connection as a connection by use - External link

Disable antivirus protection

Disable antivirus protection

How to diagnose a slowness problem?

In 99 percent of cases, slowness is a local problem, and therefore the problem can be diagnosed / solved only by trial and error.

Here are some examples:

• תנTry the netstick on another computer in the same location (check if the problem is on the computer - if the problem is indeed the computer turn to a computer technician).

• Try the netstick elsewhere (check if the problem is with your particular location - if this is the problem you can switch to another absorption company that might be better in your area or switch to a wired connection)...)

• Try another netstick if you have the option to ask someone (so you will know if the problem is in netstick - if so you can buy a new netstick, highly recommended G4).